U100.4.0
18
4.2.2 Associating a Handheld Using the Virtual Unlock Process
Note:
Associating a new transmitter using Virtual Unlock can only be done from a
transmitter that is already associated to the receiver.
This process will unlock association for
five
minutes, allowing the user to associate another
handheld to the receiver. Once association is complete or five minutes have passed, the
RECEIVER will return to a locked state.
Note:
The target receiver must be powered.
1. Turn on the handheld by pressing the STOP button.
2. Wait for the RX/TX LED to begin blinking rapidly.
3. Press and hold buttons A/B Aux1, AUX2, and then STOP.
Receiver will sound the horn and activate the Association relay to confirm the receiver is now
unlocked The handheld will then power down.
4. Go to section 4.3.
4.3 Associate a Handheld to a Receiver
This process is required when the handheld memory slot is either empty or the
user wishes to associate to a different receiver.
Note:
During this process, a receiver that is in use with another handheld cannot
be associated.
1. Turn on the handheld by pressing and releasing the
STOP
button.
2.
Within 1 second,
while the
B Select LED
is active,
simultaneously
press and release buttons A/B and AUX 2.
Handheld LEDs will begin cycling indicating the handheld is in maintenance
mode.
3. Simultaneously press and hold buttons 3 (UP) and 4 (DOWN) for approximately 5-
seconds.
4. Release the buttons when
LED A
starts to blink.
5. TX/RX LED and
B Selection LED
will become active indicating the handheld is
attempting to locate all available Warrior receivers.
6. Once the handheld has completed its search and one or more receivers have been
found, the
TX/RX LED
and
A Selection LED
become active.
If there are no receivers available, the handheld will stay in scan mode until the handheld times
out or is turned off.
7. A detected receiver will start blinking the association LED indicator and the Horn/Light
relay is engaged to sound the horn. In order to select this receiver press button AUX 2.
TX/RX LED will start blinking rapidly indicating communication is established. The
receiver ID is now stored in the handheld memory slot.
8. If the found receiver unit is
NOT
the receiver desired, press A/B AUX 1 button to scroll
through detected receivers until the desired receiver is found and blinking its association
LED indicator and pulsing the Horn/Light relay that is engaged to sound the horn. Press
button AUX 2 to select the receiver. The TX/RX LED will start blinking rapidly indicating
communication is established. The selected receiver is stored in the handheld memory
slot.
