System Manual
2018 Cervis, Inc.
15
3.1 HH2S-9XL10 Battery Installation
HH2S-9XL10 handheld units are powered by two AAA alkaline batteries. When installing
batteries, be sure to observe proper polarity as marker on the inside of the compartment to avoid
damaging the unit. To replace or install batteries in the handheld:
1. Loosen the four small Philips screws from the battery compartment cover and lift the
cover from the handheld. The screws remain attached to the cover. Make sure the
compartment sealing gasket stays in place on the handheld.
2. Install two fresh size AAA batteries. Be sure to position batteries as shown in Figure 10.
3. Replace the compartment cover and tighten the four Philips screws. These screws
should not be over tightened, but they should be tight enough to ensure the gasket
provides a proper seal.
Note:
Discard expired batteries in accordance with local regulations.
Figure 10. HH2S-9XL10 Battery Installation
Be sure to observe proper polarity when placing
batteries in the handheld battery compartment.
Caution!
