Warrior CB-xW Transmitters
U114.1.1
16
4. After three seconds, the LEDs flash in the following pattern:
– sequence repeats.
This pattern indicates that the
Tilt Switch
is enabled.
5. To disable the tilt switch, press and release the green
HORN/START
pushbutton.
The LEDs flash in the following pattern:
– sequence repeats.
This pattern indicates that the tilt switch is disabled.
Note: While the transmitter is tilted, press the green HORN/START pushbutton to
alternate between the two patterns.
6.
Once you’ve selected your desired mode, return the transmitter to its normal
operating position.
7. Press the green
HORN/START
pushbutton again to set the desired mode.
2.9.2 Switch Test Mode
Switch Test Mode
allows you to diagnose the Warrior CB-xW transmitter when troubleshooting
a potential problem.
While in switch test mode, you can test the transmitter switches, levers, and joysticks without
energizing the relays in the receiver (and consequently, unnecessarily manipulating the attached
machinery). As you manipulate the controls, the LEDs will light to let you know that the
transmitter
’s printed circuit board (PCB) recognizes that switch movement.
