Lightly grease Rear Derailleur Hanger
Fixing Nut and install either Rear Derailleur
Hanger (DRH-WMN112) or Direct Mount Rear
Derailleur Hanger (DRH-SDM) finger tight.
Final tightening will be performed after rear
wheel installation.
Do not final tighten rear derailleur
hanger assembly without rear wheel
installed. Doing so may result in a
misaligned derailleur and poor shifting.
DRH-SDM
DRH-WMN112
1. Lightly grease supplied M4 fixing screw.
Install the Threaded Fork Insert (QRI-THD)
and fixing screw, tightening only lightly.
2. Without wheel in place, install the axle
and tighten until the flange meets the fork
dropout face, but does not compress the
fork blades.
3. Tighten the fixing screw to 3Nm.
4. Remove the axle and install wheel.
Reinstall axle and tighten to 12-15Nm.
5. Remove axle and wheel, and re-torque the
fixing screw to 3Nm.
11
12
FRAME & COMPONENT PREPARATION
For use without
accessory, clip
may be hidden,
by reversing the
crossbar.
Accessory
Mount Kit-Rear
Crossbar
To install Accessory Mount -
Rear (MT-LM-R-003), replace
the rear upper crossbar of
the seatpost with the kit
version. Tighten to maximum
8Nm. See also page 19.
Clean the chainstay using isopropyl alcohol. Install the
Chainstay Protector (PRO-CS-508) by removing adhesive
backing, and fixing the guard to the frame. The bottom
rearward edge should be approximately 50mm forward
from the back of the rear dropout.
Install Front
Derailleur Mount
(FDM-590), and
ensure fixing
screws are
torqued to 3Nm.
For 1x systems
replace with the
Front Derailleur
Mount Blanking
Plate (FDM-CVR).
Torque
to 2.5Nm.
Torque to 2Nm.
Torque to 1Nm.
To install ST31 Accessory
Mount (MT-LM-F-004),
angle mount into ST31
stem faceplate and torque
to 2Nm.
or
