9
10
FRAME & COMPONENT PREPARATION
Hold the frame using a secured seatpost only.
Clamping the top tube can damage the frame
and void your warranty.
If trimming of the seatpost is required, final length should
allow for a minimum of 70mm of seatpost remaining in
the frame, or the minimum insertion dimension indicated
on the seatpost, whichever is greater. Failure to meet
this requirement, may result in damage to the frame not
covered by warranty policy, or serious injury to rider.
1. Slide Secondary Seatpost Clamp onto
seatpost.
2. Apply carbon paste to the frame and
seatpost shaft to be inserted into the frame.
3. Insert the seatpost into the frame. Adjust
height and torque the Seatpost Clamp to
6Nm maximum.
4. Torque the Secondary Seatpost Clamp to
3Nm maximum.
HB13 HANDLEBAR
Cervélo HB13
Handlebar
80mm
380mm
400mm
420mm
440mm
128mm
38cm HB-HB13-38
40cm HB-HB13-40
42cm HB-HB13-42
44cm HB-HB13-44
Use only original Cervélo components & included
hardware specified for handlebar, stem, and fork
assembly. Failure to use the specified parts and to
follow these instructions may result in a loss of
control while riding and serious injury.
Brake hoses and Di2
E-Wires run in the
channels on underside
of handlebar.
Secondary
Seatpost
Clamp
(SPC-256)
Seatpost
Clamp
(SPC-256)
