15
LOADING THE MACHINE
Always use caution when cutting bag open
.
Using a long-bladed knife, cut packages in half according to the instructions on the package. Cut about one-
quarter of your total number of packages to start, and stack the rest near the machine for easy access (Fig 14).
The process of feeding insulation into the blowing machine is fairly simple, but there are a couple of key points
to be aware of when loading.
Place one of the package halves onto the hopper tray (Fig 15-16) and align the green dotted line with the knife
slot. It’s important to note that the open part of the bag should be facing to the left or right and never into the
hopper; when positioned this way, the arrows will point into the hopper and the green dotted line will match up
with the knife slot. Remember: NEVER position the open end of the half-package facing into the hopper.
Setup and Operation
Fig. 14
Knife Slot
Green
Dotted line
Alignment arrows
Fig. 15
Fig. 16
Summary of Contents for TrueComfort
Page 18: ...18 Electrical Diagram TrueComfort System Electrical Diagram ...
Page 30: ...30 Notes ...
Page 31: ...31 Notes ...
