Cersanit AirMATIC, Installation And Operation Manual

Page: 41 / 126

41
SETS EQUIPPED WITH ELECTRONIC CONTROLLERS - MICRO
6.3 Description of water system function
In order to activate the water system, the bathtub must be filled to the required level.
NOTICE!
Unless the bathtub is filled, pressing the water system pushbutton does not activate the system.
1 short press - activates the water system constant operation mode.
2 short press - deactivates the water system constant and pulsed operation mode.
1 pressed and held - activates the water system pulsed operation mode.
This mode may be activated as the subsequent mode after .
the constant operation mode is activated. .
Pulsed system operation is indicated by blinking LED 4.
2 pressed and held - deactivates the water system pulsed operation mode.
The air system is automatically deactivated 20 minutes after its activation unless it is deactivated manually before this time
elapses.
A bathtub equipped with the massage water system function has an additional manual aeration regulator. It is located on
the upper bathtub surface next to the electronic panel and is used to enrich the water jet with air bubbles.
- aeration regulator knob.
6.4 Description of water-air system functions
The water-air system is equipped with all functions of both systems described above. They may operate separately,
independently or together. Each system has its own set of control pushbuttons. Water and air massage parameter setting
is done separately, which does not prevent the user from setting them in the same way.
6.5 Drying of air system lines
This function is used to dry air system lines when the massage is completed. It lasts 45 seconds and is automatically
deactivated when this time elapses.
In order to activate this function, the following conditions must be fulfilled:
- bathtub must be equipped with the air massage system,
- water must be drained from the bathtub.
6
INST
ALLA
TION
AND OPERA
TION MANUAL
BA
THTUB WITH MASSAGE SYSTEM
EN
!