Cersanit AirMATIC, Installation And Operation Manual

Page: 36 / 126

36
INST
ALLA
TION
AND OPERA
TION MANUAL
BA
THTUB WITH MASSAGE SYSTEM
EN
5 SETS EQUIPPED WITH ELECTRONIC CONTROLLERS
2 press activates the second of four available pulsed massage functions.
Pulsed system operation is indicated by an active LED in the area surrounding the pushbutton.
3 press activates the third of four available pulsed massage functions.
Pulsed system operation is indicated by an active LED in the area surrounding the pushbutton.
4 press activates the fourth of four available pulsed massage functions.
Pulsed system operation is indicated by an active LED in the area surrounding the pushbutton.
5 press deactivates massage pulsed operation (the appliance returns to the status before the .
pushbutton was pressed for the first time).
The end of system pulsed operation is indicated by deactivation of .
the LED in the area surrounding the pushbutton.
The bathtub with water system is additionally fitted with a manual aeration regulator.
It is located on the upper bathtub surface next to the electronic panel and is used to enrich the water jet with air bubbles.
- aeration regulator knob.
The water system is automatically deactivated when the preset massage time elapses unless it is manually deactivated
earlier.
5.5 Description of water-air system functions
The water-air system is equipped with all functions of both systems described above. They may operate separately,
independently or together. Each system has its own set of control pushbuttons. Water and air massage parameter setting
is done separately, which does not prevent the user from setting them in the same way.
5.6 Additional controller functions.
As well as the standard massage functions, the controller supports other functions making the bath more enjoyable and
facilitating the maintenance and servicing of the appliance. However, the above functions are available only on customised
appliances.
5.6.1 Bathtub automatic disinfection.
This function is used to disinfect and clean the water circulation system from impurities left after massages. To this end,
a special cleaning process is automatically activated. The user must only make sure that there is an adequate amount of
the cleaning liquid in the appliance and activate the process by means of the control panel. The duration of the disinfection
process is 3.5 minutes. When this function is active, access to all other functions is blocked.
,, ’’
,, ’’
,, ’’