Cermetek Microelectronics, Inc Page 32 of 42
Document NO. 607-00xx Revision A (12/13)
4.2.5.12
AT+WSLK
: This command allows the user to Read the WiFi Link Status.
Read WiFi Link Status
AT+ WSLK<CR>
+ok=<ret ><CR>< LF ><CR>< LF >
Parameters:
ret = Disconnected (no WiFi connection)
= “AP” SSID (Access Points MAC address)
=
“RF Off (WiFi disabled)
Note: New settings for AT+WSLK do not become active until the CH232BGN module reboots.
This command is only active in Station mode.
4.2.5.13
AT+WEBU
: This command allows the user to Set or Read Web Page login parameters
Read Web Page Login Parameters
AT+WEBU<CR>
+ok=<usr,password><CR>< LF ><CR>< LF >
Set Web Page Login Parameters
AT+WSSID=<usr,password ><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
usr = User Name for web page access
password = Web page password
4.2.5.14
AT+WAP
: this command permits the user to Set or Read Access Point Parameters.
Read Access Point Parameters
AT+WAP<CR>
+ok=<wifi_mode,ssid,channel><CR>< LF ><CR>< LF >
Set Access Point Parameters
AT+WAP=< wifi_mode,ssid,channel ><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
Wifi_mode = 11BG
= 11B
= 11G
= 11BGN
=11N
ssid = Service Set Identifier
channel = Auto (automatic channel selection)
= CH1 to CH11 (use designated channel)
Note: New settings for AT+WAP do not become active until the CH232BGN module reboots.
This command is only active in Station mode.
