Cermetek Microelectronics, Inc Page 31 of 42
Document NO. 607-00xx Revision A (12/13)
4.2.5.10
AT+WSKEY
: This command sets/reads the WiFi security parameters.
Read WiFi Security Parameters
AT+WSKEY<CR>
+ok=<auth,encrypt,key><CR>< LF ><CR>< LF >
Set WiFi Security Parameters
AT+WSKEY=<auth,encrypt,key><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
auth (Authentication Mode) = OPEN;
= Shared
= WPAPSK
Encry (Encryption) = None (with authorization set to open)
= WEP (with authorization set to open or shared)
= TKIP (with WPAPSK selected)
= AES (with WPAPSK selected)
Key (Password) = ASCII code between 8 and 64 bits
Note: New settings AT+WSKEY do not become active until the CH232BGN module reboots.
This command is only active in Station mode.
4.2.5.11
AT+WSSSID
: This command allows the user to Read or Set WiFi Service Set Identifier in
the CH232BGN.
Read WiFi SSID Paramters
AT+WSSID<CR>
+ok=<ap’s ssid ><CR>< LF ><CR>< LF >
Set WiFi MSSID Parameters
AT+WSSID=<mode ><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
ap’s ssid = Service Set identifier of the local Access Point
Note: New settings for AT+WSSID do not become active until the CH232BGN module reboots.
This command is only active in Station mode.
