7
Installation and Wiring Instructions
2. Adding or Replacing 4 Valve Module
Attention: Modules may be added or replaced only in the AC-800248 Model
In order to add or replace a 4 valve module the following procedures must be performed:
1. Turn selector to Testing mode.
2. Disconnect the AC-24V wire.
3. Wait one minute.
4. Remove battery.
5. With a "cross-head" screwdriver, open
screws on front of module.
6. Add or replace module by pushing it in or
pulling it out.
7. Fasten screws at front of module.
8. Replace battery in position.
9. Reconnect the AC-24V wire.
The number of valves the controller will
now
operate will appear on the LCD display.
The current time must be set.
THE PROGRAMS INSTALLED IN THE CONTROLLER WILL BE STORED
WHEN DISCONNECTED FROM ELECTRICITY (20 YEARS MEMORY!)
- module
- screws
- connector
EN
Summary of Contents for CMC-08-24
Page 72: ......
