Page 15
For technical questions, please call 1-800-444-3353.
SKU 67595
phaSe 5: table assembly
a
c
j
k
required hardware
letter
description
qty
(for this phase)
A
M8 x 80 Table Stop Bolt
1
C
M8 x 30 Bolt
2
J
M8 Lock Washer
2
K
M8 Nut
1
Figure For StepS 5-1 to 5-3
132B
attach through
theSe holeS
With BoltS (c)
taBle Stop
Bolt (a) hole
1. Set the Table Bracket (132B) onto the
saw body as shown above. Note that
the Table Stop bolt hole is on the side
with the Pulleys. The saw body has
alignment pins pre-installed to align the
Table Bracket properly.
Secure the Table Bracket to the Saw
2.
Body using Bolts (C) and Lock Wash-
ers (J) through the holes noted above.
Tighten securely in place.
Thread the Nut (K) onto the Table Stop
3.
Bolt (A). Install the Table Stop Bolt into
the hole noted in the figure above.
Figure For Step 5-4
132B
112B
4. Attach the Lower Support Bracket (112B)
to the saw body near the Table Bracket
(132B). Secure in place with two Bolts
(119B) and Washers (120B) as shown
above. The hardware for this step is
packaged separately from the hardware
bag.
Figure For Step 5-5
taBle (36B)
aSSeMBlY
132B
128B
128B
127B
127B
5. Locate the Table Bracket (132B). Note
that there are two Bolts (128B) extend-
ing out from the bottom of the Trunnions
(127B). Insert those two Bolts through
the holes in the Table Bracket (132B) as
shown above. Secure the Bolts in place
using Knobs (131B).