Page 13
For technical questions, please call 1-800-444-3353.
SKU 67595
Figure For Step 3-4
(cutaway view.)
ShaFt
pulle
Y
pulle
Y
k
eY
Set Scre
W
depth
gauge
4. Hold the Pulley in place and insert the
depth gauge you made in step 4-2 (Bolt
(G) and Nut (N)) into the key slot, push-
ing the key into position. The depth
gauge can now be disassembled and
placed with the other hardware.
While holding the Pulley in place, tighten
5.
the Set Screw (10D) in the side of the
Pulley to secure it to the shaft. The Pul-
ley no longer needs to be held in place.
Motor Mounting
Have an assistant hold the Motor (11A)
6.
in place while it is attached to the Motor
Plate (10A).
Figure For Step 3-7
11a
10a
pulleYS
Should
line up.
7. There are two sets of slots on the Motor
Plate (10A). Line the Motor Pulley (3D)
up with the Pulley (1D) above it.
Insert a Bolt (D) and Washer (H) through
8.
each hole from one side, and secure the
Bolt with a Washer (H), Lock Washer (J),
and Nut (K). Leave the Nuts snug, but
do not tighten them completely yet.
Remove the nylon cable tie that secured
9.
the Power Cord (14A) during shipment.