Page 12
For technical questions, please call 1-800-444-3353.
SKU 67595
Figure For Step 2-2
SaW
BodY
1a
2. With at least one assistant, lower the
Bandsaw Body down on the Stand.
Make sure that the holes in the Body line
up with the slots in the stand (See Figure
2-1), and that the pulley lines up over the
belt cutout as shown above.
Insert the four Bolts (B) through one
3.
Washer (H) each and into the holes in
the Saw Body from the top.
Attach each Bolt (B) using a Washer
4.
(H), Lock Washer (J), and Nut (K).
Leave the hardware only finger tight.
Measure to verify that the saw body is
5.
properly aligned to the stand. Make
needed adjustments, then wrench tight-
en the hardware.
phaSe 3: Motor to Stand assembly
d
h
j
k
required hardware
letter
description
qty
(for this phase)
D
M8 x 25 Bolt
4
H
M8 Washer
8
J
M8 Lock Washer
4
K
M8 Nut
4
pulley Mounting
Remove the tape securing the key to
1.
the shaft of the Motor (11A). Set the key
aside.
Figure For Step 3-2
g
n
~0.3”
2. The key for this saw’s Motor shaft will
need to be offset by about 0.3” from the
end of the shaft to allow the Set Screw
to function properly. To assist in this,
thread a M5 Nut (N) all the way onto a
M5 x 15 Pan Head Bolt (G) for temporary
use as a depth gauge.
Figure For Step 3-3
3. Slide the Pulley (3D) over the end of the
Motor (11A) shaft, larger end first. Line
up the key slots in both the Pulley and
the shaft. Slide the key into the key
slots. Align the end of the Pulley, key,
and shaft with one another. The Pulley
will need to be held in position for now.