Page 10
SKU 45656
For technical questions, please call 1-800-444-3353.
Place the wheel on the four Jaws (17C) and, while keeping the wheel rim
pressed down, depress the Jaw Clamp Pedal (26E)
as far down
as it will go.
Check to make sure the wheel is firmly secured by the Jaws (17C).
Rims from 12” to 20”:
Position the four Jaws (17C) so that they are completely
closed.
Place the wheel on the four Jaws (17C) and depress the Jaw Clamp Pedal (26E)
to open the Jaws, thereby locking the wheel rim in place.
Check to make sure the wheel is firmly secured by the Jaws (17C).
5.
TOOLS SHAFT
(#13A)
MOUNTING
HEAD (#15A)
LEVER (#1F)
FIGURE I
Lower the Tools Shaft (13A) until the Mounting Head (15A) rests next to the
wheel rim and on top of the tire. Then, lock the Tools Shaft in position, using the
Block Support (7A).
(See Figures E and I.)
6.
Insert the Lever (1F) between the tire bead and the front section of the Mounting
Head (15A).
(See Figures E and I.)
7.
Move the tire bead over the Mounting Head (15A) by pulling
upward
on the
Reverse Pedal (59E). NOTE: To avoid damaging the inner tube (if there is one),
it is recommended to perform this Step with the inner tube valve stem positioned
about 1” to the right of the Mounting Head.
(See Figures B and I.)
8.
With the Lever (1F) held in position, rotate the Turntable (1C) in a
clockwise
direction by fully
depressing
the Reverse Pedal (59E). Continue until the tire is
completely separated from the wheel rim.
9.
Remove the inner tube (if there is one), and repeat the above Steps for the other
side of the wheel/tire.
