Page 18
For technical questions, please call 1-888-866-5797.
Item 38470
The Letter “Q”
Four blanks are required for this letter:
•
14″ long
•
3-7/8″ long
•
2″ long
•
3/4″ long
1st Bend
2nd
3rd
4th
1-1/4″
2-1/2″
5th 6th
1-1/4″
1-1/4″
2-1/2″
1-1/4″
1.
Refer to making the letter “O” on page 21. Using chalk, mark off 1-1/4″ in from
each side. Then from the first mark, mark off 2-1/2″ on each side.
2.
From the inside mark, measure in another 1-1/4″ and mark it off.
3. Set the Right Angle Bend Attachment into place.
4. Set the stock in the Bender so that the Right Angle Bend Attachment will bend at the first chalk mark. Bend to 45°.
5. Make a bend at your second chalk mark to 45 degrees. Repeat for the third mark.
6. Take the stock out of the Bender. Insert the second side. Repeat steps 4 and 5.
7.
Weld the 3-7/8″ piece to the open side so that a complete circle is formed.
8. Weld the two short pieces to the right bottom corner of the circle you just completed.
The 2″ blank should be welded to the inside, with the 3/4″ blank on the outside.
The Letter “R”
Two blanks are required for this letter:
•
8-7/8″
•
6″
•
3-1/8″
1st Bend
2nd
3rd 4th
2-3/4″
1″
2-3/4″
1″
1.
Refer to directions for making a “P” on page 22. Using chalk, mark off 2-3/4″ in from each
side of the long blank. From this first mark, mark off one inch on each side.
2. Set the Right Angle Bend Attachment into place.
3. Set the stock in the Bender so that the Right Angle Bend Attachment will bend at the first chalk mark. Bend to 45°.
4. Move the stock to the second chalk mark and bend to 45°.
5. Pull the stock out of the bender and insert the stock with the opposite
end in the bender. Make the 3rd bend at 45°.
6. Slide the stock to the fourth position and bend to 45°.
7.
Weld the loop to the top of the 6″ piece to form a letter “P”.
8.
Weld the 3-1/8″ blank opposite the leg of the “P”. You will have to weld it at a slight outward angle to form an “R”.
