Handle to
lock
the Rip Fence Assembly in place.
(See Figure D.)
To Adjust The Miter Gauge Assembly:
1.
CAUTION: Prior to performing this procedure, make sure the Power Switch
(part #36) is in its “STOP” position and that the Motor Cord (part #31) is
unplugged from its electrical power outlet. (See Figure B.)
2.
Slide the Guide Bar of the Miter Gauge Assembly (part #173*) into the Table Slot
located on the right side of the Table (part #126). Loosen the Pan Head Bolt and
move the Miter Gauge Body to the
right
or
left
to acquire the desired angle of cut
as indicated by the Pointer and Scale. Then, tighten the Pan Head Bolt to
lock
the Miter Gauge Assembly in place.
(See Figure E.)
TOP VIEW
TABLE
SLOT
TABLE
(#126)
GUIDE BAR
SCALE
POINTER
MITER GAUGE BODY
HANDLE
PAN HEAD BOLT
MITER GAUGE ASSY. (#173*)
FIGURE E
To Change The Saw Blade:
1.
CAUTION: Prior to performing this procedure, make sure the Power Switch
(part #36) is in its “STOP” position and that the Motor Cord (part #31) is
unplugged from its electrical power outlet. (See Figure B.)
2.
NOTE:
While performing this procedure, it is recommended to wear heavy duty
work gloves to avoid cuts to hands and fingers.
3.
Remove the Table Insert (part #127) and Table Pin (part #128).
(See Figure B.)
4.
Open the Upper Wheel Cover (part #55) and Lower Wheel Cover (part #95).
(See Figure B.)
SKU 03179
PAGE 11
