9
9
MOOD 1818WP User Manual
Eng
4) DMX Output
Female 3-pin XLR socket for sending the DMX control signal to other units.
5) 4 Digit LED Display & Control Buttons
This section of rear panel shows the operating mode and allows the user to setup
the unit
1
4
2 3
1. MENU Button
- Short-press it to switch the setting pages (please read para-
graph “7 - Menu Operation” on page 11 for further details about menus and
settings).
2. UP Button
- It scrolls up individual items in the selection menu and sub-menus
for system settings (DMX address, Operation Mode, etc.) and increases values/
settings of parameters.
3. DOWN Button
- It scrolls down individual items in the selection menu and sub-
menus for system settings (DMX address, Operation Mode, etc.) and decreases
values/settings of parameters.
4. ENTER Button
- Press ENTER to access menu levels and confirm parameter
value changes.
6.2. Power and Wiring
y
Always make sure that the voltage of the outlet to which you are connecting the
product is within the range stated in paragraph “10 - Specification” on page
14 or rear panel of the product (AC100V-240V 50/60Hz).
y
Make sure the power cord is not crimped or damaged. Never connect this prod-
uct to a dimmer pack or rheostat.
y
Never disconnect the product from power cord by pulling or tugging on the cord.
y
To avoid electric shock, all fixtures must be connected to circuits with a suitable
ground and circuit breaker.
6.3. Mains Connections
Connect the device to the mains with the supplied power cable. Wire correspon-
dence is as follows:
