11
11
MOOD 1818WP User Manual
Eng
The DMX terminator is simply an XLR connector with a 120Ω (ohm), 1/4 Watt resistor
connected across Signal (-) and Signal (+), respectively, pins 2 and 3, which is then
plugged into the output socket on last projector in the chain. The connections are
illustrated below.
120ohm, 1/4W
Resistor
DMX Terminator
Complimentary signal cable can transmits signals to 20 unit fixtures at most.
Signal amplifier is a must to connect more fixtures.
6.6. 3-Pin vs 5-Pin DMX cables
DMX connection protocols used by controllers and fixtures manufacturers are not
standardized around the world. However, two are the most common standards:
5-Pin XLR and 3-Pin XLR system. If you wish to connect this fixture to a 5-Pin XLR in-
put fixture, you need to use an adapter-cable or make it by yourself. Below you can
see the wiring correspondence between 3-Pin and 5-Pin plug and socket standards
5-Pins XLR (plug)
Pin 1: GND (Screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
Pin 4: N/C
Pin 5: N/C
3-Pins XLR (socket)
Pin 1: GND (Screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
5-Pins XLR (socket)
Pin 1: GND (Screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
Pin 4: N/C
Pin 5: N/C
3-Pins XLR (plug)
Pin 1: GND (Screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
7 - M
enu
o
PeraTion
By pressing MENU button, the display will show the main function menu.
Display
Instruction
A001 (A001 - A512)
10-1 channel mode
d001 (d001 - d512)
6 channel mode
H001 (H001 - H512)
10-2 channel mode
CL01 (CL01 - CL32)
32 build-in color
CC01 (CC01 - CC99)
Color jump effect, speed from slow to fast
EE01 (EE01 - EE99)
Slow off-quick on effect, speed from slow to
fast
FF01 (FF01 - FF99)
Color fade effect, speed from slow to fast
ST01 (ST01 - ST32)
SP01 - SP99
1-32 kinds of strobe effect
Speed from slow to fast
