CENGAR SAWS
are hand held reciprocating saws designed to cut metals and plastics in
production environments and can be used in Atex zoned areas where
appropriate. They should only be used by trained operators who are
responsible for the safety of themselves and others in the vicinity. Saw
blades are capable of causing serious injury
Think safe Act safe Be safe
LUBRICATION
Use Cengar Green Oil with longer lasting coating properties for best
results. Cengar Green Oil is specially prepared to: -
1
Emulsify the water generally found in compressed air lines.
2
Give perfect mist lubrication.
3
Remain fluid at the low working temperature of compressed air tools.
4
Contains corrosion and oxidation inhibitors.
Incorrect oils if used will soon “break down” forming a sludge which will
slow and eventually stop the action of the saw. See maintenance details.
INSTALLATION OF BLADES.
Before attempting to insert or change a blade, ensure that the air supply is
isolated by operating the isolation valve provided. Loosen the retaining
grub screws with the key provided, insert blade through nosepiece so that
the teeth are cutting on the pull stroke.
Locate the back screw in the hole in the end of the blade, for a positive
drive, the front screw can then be tightened to grip the blade firmly.
BLADES
Cengar “Shatterproof” Bi-Metal blades are specially prepared for use with
Cengar saws, to withstand the high operating speeds, and give maximum
cutting life.
Choose the teeth per inch to suit the characteristics of the material being
cut.
Choose pitch to ensure that at least 3 or 4 teeth are cutting at the same time.
(See chart on page 14 for guidance)
