11
4.4) Controls
When gripping handlebar (11), the operator can easily access all the unit controls and, more specifi cally:
Worklights ON/OFF switch (04):
two high effi
ciency LED lights allow the clamp area to be eff ectively lit in
poor light conditions and at night.
Brake release lever (12):
for safety reasons the machine is equipped with a "dead man's" braking system on the
rear wheel. It is only possible to release the brake by pressing the lever (12), allowing the machine to move
along the rail.
Clamp operation button (13):
enables operation of the clamps according to the mode selected with switch
(15).
Settings button (14):
enables the machine to memorise the clamp position set for sleeper lifting.
Clamp control selector (15):
allows the selection of insertion
"IN"
or extraction
"OUT"
of the clamps.
Clamp return button (16):
enables the clamps to be brought back to their starting position.
With clamp control selector (15) on
“OUT”
it enables insertion of the clamps at a lower speed.
Stop/emergency button (17)
in a very visible position and easy to operate to stop the machine normally
and in case of an emergency.
NOTE: when this button is pressed it remains in OFF position. To start the engine, the button should be turned
clockwise so that it lifts automatically into the ON position.
The engine will not start unless the red button (17) is lifted.
FIG. 7
16
13
12
04
17
15
14
11
