8
4.1) Assembling the machine
Select the rail to be worked on and the direction of operation, then assemble the machine as follows, referring
to Fig. 4:
1
–
With knob (09) engaged and wheel (33) blocked, lift the
clamp unit
by means of the handles (24 & 32) and
rest this on the selected rail, positioning it at a sleeper for stability.
2
–
Rest the
support carriage
on the track then pull and turn the fastening/release knobs (45).
Lift the clamp unit by the handle (24) and locate pins (25) fully into their carriage housings as far as the
stop. Release knob (45) to lock the clamp unit.
3
–
Pull and turn knob (43), insert the
3
rd
wheel bar
in the carriage housing as far as the stop, aligning the hole
in the end of the arm with the pin knob.
Release knob (43) so wheel (47) can act as a support on the opposite rail and make the assembly stable
and able to slide along the rail. The arm can be fi tted to the carriage from either side for convenience in
selecting the direction of work.
4
–
Pull and turn knobs (20) at the base of the pump unit. Lift the
pump unit
by handles (01) and handlebar
(11). Rest the pump unit on the clamp unit and align pins (26) with the relevant locating holes on the
under side of the pump unit. Release the knobs to lock.
5
–
Unscrew handlebar locking wingnut (07) and rotate handlebar (11)
to a confortable position, tighten the wingnut fully to lock the handle.
6
–
Plug electrical connector (29) into socket (05).
Attach
fl exible hydraulic hoses (30)
by means of the quick cou-
plings to the respective sockets (06 & 08) on the clamp unit.
7
–
Attach brake release (09) (Ref. to
§ 4.1.1
) and adjust the gas springs
of the rear wheel arm using knob (31).
4.1.1) Braking system
(Ref. to Fig. 3a, 3b, 3c, 4)
To move the machine along the rail, it is necessary to attach brake release
(09) to socket (37) on the rear arm as follows:
Introduce end part (A) into slot seat (B) located above the wheel of the
rear support arm (Ref. to Fig. 3a).
Pull handle (C) upwards, release it in position then push until it is locked
(Ref. to Fig. 3b and c).
Press lever (12) to verify the correct engagement and disengagement
of pin (P) from the wheel (Ref. to Fig. 3c).
During disassembly of the machine, before removal of the pump unit,
the brake release must be detached as follows:
Pull handle (C) and detach end (A) from slot seat (B).
A
B
FIG. 3a
09
FIG. 3b
FIG. 3c
4. INSTRUCTIONS FOR USE
37
C
P
