4
ENGLISH
CANVAS BAG
Before commencing the cutting operation ensure that the latch is fully secured: partial closure
may damage the tool head.
2.2) Blade advancement
Operate moveable handle (44) for lower blade advancement. This fi rst stage rapidly closes the
lower blade to the conductor. Make sure that blades (18 and 23) are exactly positioned on desired
cutting point, otherwise re-open blades following instructions as §
2.4
and re-position the cable.
2.3) Cutting
Continue operating the moveable handle, the lower blade advances gradually until the cable is
fully cut.
T
HE
TOOL
IS
DESIGNED
FOR
CUTTING
COPPER
,
ALUMINIUM
AND
ALUMINIUM
STEEL
REIN
FORCED
CABLES
.
D
O
NOT
ATTEMPT
TO
CUT
GUY
WIRE
AND
GROUND
ROD
.
2.4) Blade opening
Press the pressure release lever (58) for the rapid retraction of the ram and subsequent blade (18)
opening.
2.5) Rest setting
After completion of the work, press the release lever (58) to release the oil pressure (ref.
§ 2.4
).
3. WARNING
The tool is robust and requires very little daily maintenance.
Compliance with the following points, should help to maintain the optimum performance of the tool:
3.1)
Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be cleaned with a clean cloth, taking care to remove any residual,
especially close to pin and moveable parts.
3.2) Storage
When not in use, the tool should be
stored and transported in the canvas
bag, to prevent damage.
Canvas bag: ref.
010
; size
545 x 160 mm (21.4 x 6.3 in.);
weight 0,15 kg (0.3 lbs).
