6
ENGLISH
5. BLADE REPLACEMENT
(Ref. to Fig. 3 )
After extended use, the blades may loose their cutting edge.
Replace the blades as follows:
5.1) Lower blade
– Release latch (28), open the head.
– Operate moveable handle to advance the lower blade (18) until holding screw (29) is visible on
the ram (14).
– Using a fl at blade, screwdriver remove the holding screw (29) and release the lower blade (18).
– Insert the new blade and fi t the holding screw.
Warning: before closing the head release the oil pressure and retract the lower blade (18), otherwise
the tool head assembly may hit and damage the lower blade.
5.2) Upper blade
– Release latch (28), open the head.
– Remove the circlip (20) and extract the head pin (19), enough to release the tool head assembly.
– Remove circlip (25) and pin (26), to release the latch (28). Remove latch spring from the upper
blade.
– Unscrew the 4 screws (21), remove the left hand guide (22), the right hand guide (24) and release
the blade (23).
– Fit the left and right hand guides to the new blade. Place the spring into its seat and refi t the latch.
– Fit the blade assembly to the head (13), fully insert the pin (19) and secure with the circlip (20).
6. RETURN TO
Cembre
FOR OVERHAUL
In the case of a breakdown contact our Area Agent who will advise you on the problem and give
you the necessary instructions on how to dispatch the tool to our nearest service Centre; if possible,
attach a copy of the Test Certifi cate supplied by
Cembre
together with the tool or fi ll in and attach
the form available in the “ASSISTANCE” section of the
Cembre
website.
