19
6.4
End sleeve in-feed is disrupted
Check the feeder bowl
•
Check if the winged screw (1) is loose, if necessary, re-tighten.
•
Tuck the end sleeves into the transport grooves.
•
Change the speed of the feeder bowl.
Check the baffles
•
Switch off the EPB-1N at the mains switch.
•
Unscrew the baffle covering with the hexagonal wrench.
•
Remove the defect end sleeves.
Check the sleeve feeding
•
Unscrew the separation plate (1) using the hexagonal wrench.
•
Remove the reversing base sleeve (2).
•
Push the cable through the feeder (3) and, if necessary,
remove the crimped end sleeves.
Check the reversing base sleeve
•
Unscrew allen screw (1) on the reversing base sleeve using a
hexagonal wrench and open the reversing base sleeve.
•
Remove the crimped end sleeves.
•
Clean the feeder channel (2) and air pressure channel (3).
WARNING: Risk of injury!
Disconnect the mains plug and the com-
pressed air before you open the front door.
1
