Cello 1008 CT 3240, Instruction Manual

Page: 13 / 44

12
on position at the regulator. To create a spark you must push the control knob in (A) and hold
in this position for 3-
5 seconds to allow gas flow and then turn anticlockwise to” HIGH” (B). It
can spark to the burner lighting tube (C). You will hear a “snap” from the igniter and you will
also see a 3”-5” orange flame coming from the burner lighting tube at the left side of the
burner (D).
Continue to hold the burner control knob in for two seconds after the “snap”, this will allow
gas to flow completely down the burner tube (E) and insure ignition.
When the burner is alight, adjacent burners will cross light when their controls are turned to
“HIGH”
At “High” setting the burner flame should be approximately 12-20mm long with a minimum of
orange flame. Turn the gas control fully anticlockwise for minimum setting.
Should you have any difficulty lighting your gas grill following the above steps, contact your
dealer for advice.
Warning : If the burner still does not light ,turn the bu
rner control knob to” OFF”
and wait 5 minutes to let the gas clear before lighting again.