8
4. Preparation
You will need to purchase a LPG gas bottle and the pressure regulator should correspond to
the pressure and gas category of the appliance, which can be obtained from your nearest
Gas Retailer. The regulator should be complying with EN16129 with current version and
national regulation.
You will need to purchase a gas cylinder and a 28-30/37 mbar regulator for I3+(28-30/37)
and 30mbar regulator for I3B/P(30), 50 mbar regulator for I3B/P(50) to operate this gas grill.
which can be obtained from your nearest Gas Retailer.
See point 9 for further instructions.
Strongly Recommends Information:
When using the gas cylinder, it must always be kept in upright position.
This appliance must only be used with an approved hose and regulator.
Energy saving tips:
a) Reduce the opening time of the lid.
b) Turn the grill off as soon as cooking is completed.
c) Preheat the gas grill for 10 to 15 minutes only.
(Except for the first use)
d) Do not preheat longer then recommended.
e) Do not use a higher setting than required.
Connect the hose and regulator to the gas container at the right side of the gas grill .Keeping
in mind that the gas container must be kept away from heat and in a safe position .The hose
dimension is 8mm diameter. The gas hose must be approved in Finland with a diameter of
10 mm the LPG hose and its length must not exceed 1.2 m.
5. Installation
After purchasing your gas bottle you will then be ready to set it up with your gas grill.
a)
When changing the gas bottle which shall be carried out away from any source of
ignition.
Position the gas bottle at the side of your gas grill, not underneath, keeping in
mind that the bottle must be kept away from heat and in a safe position.
b) When ready to use your gas grill insert the regulator into the gas cylinder valve and
tighten firmly. The recommended hose length is about 1.0 m. The hose must not be
longer than 1.2 m.
Warning:
Before attempting to light your gas grill you must refer to your lighting
instructions and warning / safety points.
Check the hose before each use, searching for cracking, cuts or any abrasions. If the hose is
found to be faulty in any way do not attempt to use your gas grill.
When changing your gas bottle ensures that there are no sources of ignition close by i.e.
fires, cigarettes, naked flames etc. Make sure that the appliance is switched off.
Summary of Contents for 1008 CT 3240
