Cellink 000000020356, User Manual

Page: 33 / 48

29
05 Relevant G-code commands
G7 Znnn Ennn Fnnn
When used in combination with the G90 command, which defines absolute coordinates,
G7 is the relative move command. The value for the Z parameter is the coordinate (in mm)
directing where to move relative to the current position. E tells the BIO X to open the valve
for extrusion. The F parameter is the speed of the printhead in mm/min.
G92 Xnnn Ynnn Znnn G92 sets the current position of the printhead to the specified X, Y and Z coordinates. If no
values are given, the position is assumed to be 0, 0, 0 (this will also change the Z position).
Tx Switch between printhead (x). Where 0, 1, 2 designate printheads 1, 2 and 3.
M771 Tx Pyy M771 turns on the heater in printhead Tx at temperature Pyy. yy is between 30 and 65
degrees Celsius.