Cellink 000000020356, User Manual

Page: 16 / 48

12
04 Getting started
4.1 Unpacking and installation
NOTE: The printing parameters displayed on this manual might not be accurate for your specific protocol. For
recommended parameters please consult the documentation for the bioink being used.
1. Open the package. Remove the 10-mL Pneumatic Printhead.
2. Attach the 10-mL Pneumatic Printhead to the BIO X printbox. Align the printhead above the desired printhead mount (Figure 2A) and push
downward using one hand. Secure the bottom of the prinhead mount with your opposite hand to avoid straining the motor (Figure 2B,C,D).
A
B
C D
Figure 2: Attaching the Pneumatic Printhead to the BIO X. (A) Line up the printhead with a mount on the printbox. (B) Slide the printhead down
with one hand and secure the bottom of the printhead mount with the other hand. Once attached, the lights on the printhead will turn from
white to blue.