If you press
AUTO
too late, or want to start again for any reason, press and
hold the
AUTO
button for 2 seconds to start over.
9. The
AUTO
on the other channel starts flashing.
· If you only use one channel: Wait a few seconds and the
AUTO
stops flas-
hing.
· If you use both channels: Press the other channel’s
AUTO
P
AUTO
S
, to confirm
the two channel use. The other channel’s auto test starts. Repeat step 8 to
set the amplitude.
The amplitude is now optimized for you and the training program will start
after a few seconds. When the program is finished the timer flashes ”00:00”.
AUTO
P
AUTO
S
or
AUTO
P
AUTO
S
can be used to increase or decrease stimulation amplitude at
any time until the stimulation feels pleasant, presumed that the key lock is
inactivated. If doing so, the Automatic Amplitude Setting is lost and the stimu-
lator goes to Manual Amplitude Setting.
MANUAL AMPLITUDE SETTING
Prepare the equipment as described in
Step-by-Step Use
, step 1-6
7. Press
AUTO
P
AUTO
S
to set the amplitude and start the stimulation.
8. Increase or decrease the amplitude using
AUTO
P
AUTO
S
and
AUTO
P
AUTO
S
until you reach a
comfortable level. Always increase the amplitude cautiously.
When the program is finished the amplitude automatically returns to 0, and
the timer flashes ”00:00”.
Note:
Do not forget to set the amplitude for the Active Rest (in manual mode
only), see section
Active Rest.
2526_CEFAR_MYO.ACTIV_X2__ENG_3-18 8
2006-07-07 11:09:58
Summary of Contents for activ X2
Page 14: ...195 2526_CEFAR_MYO ACTIV_X2_EP_195 2195 195 2006 07 07 11 49 39...
Page 15: ...196 2526_CEFAR_MYO ACTIV_X2_EP_195 2196 196 2006 07 07 11 49 40...
Page 16: ...197 2526_CEFAR_MYO ACTIV_X2_EP_195 2197 197 2006 07 07 11 49 41...
Page 17: ...198 2526_CEFAR_MYO ACTIV_X2_EP_195 2198 198 2006 07 07 11 49 42...
