ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
9
5.0 RECOMMENDED TOOLS AND TEST EQUIPMENT
DTMF Test Set
Volt/Ohm Meter
3/8" Nut Driver
5/16" Nut Driver
Flat Blade Screw Driver
Security Tool CEECO P/N 301-064
6.0 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS
6.1
Using a 301-064 security tool (
sold separately
) remove the four security
screws.
6.2
The security tool is for a standard 5/32" button head screw generally used
on the framework of the phone booths.
6.3
Separate the cover assembly from the housing.
6.4
Run the inside station wire through the housing and terminate on to the
RJ11C modular jack, as depicted on the following page. The CEECO-
provided modular jack must be used, as it contains required over-voltage
protection.
6.5
The use of a gas tube or carbon station protector is recommended. The
station ground should not exceed 50 ohms.
6.6
Plug the modular line cord from the SPK 660-000 PC board into the
RJ11C terminal block.
6.7
Dress the line cord away from the security screws and seat the faceplate
into the enclosure.
6.8
Secure the cover assembly by tightening the security screws.
*****WARNING*****
A.
Never install telephone wiring during a lightning storm.
B.
Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
C.
Never touches uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
D.
Use caution when installing or modifying telephone lines.
