ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
8
6.0 INSTALLATION
NOTES
AND ASSEMBLY INSTRUCTIONS
6.1
The SSP-373-D is designed to be mounted inside any apparatus box with
dimensions of 6 7/8
∀
W x 9 3/4
∀
H x 3
∀
D or greater. CEECO part
number 371-011 is an apparatus box, which is well suited for this purpose.
Four mounting holes are required inside the box. If the holes are not
tapped, then self-tapping screws should be used when mounting the panel.
It is best to use the security screws, which do require tapped mounting
holes.
6.2
Mount the two mounting support brackets provided to the apparatus box
being used. Route the inside station wire and terminate to an RJ11C
modular jack or terminal block.
6.3
The use of a gas tube station protector is recommended. The station
ground should not exceed 50 ohms.
6.4
Plug the modular line cord from the telephone assembly into the RJ11C
modular jack or terminal block. Dress the line cable away from the
mounting holes. Install the telephone assembly by placing it into its
mounting box and securing it with the four security screws. The security
tool (CEECO part number 301-037 sold separately) will be needed.
*****WARNING*****
A.
Never install telephone wiring during a lightning storm.
B.
Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
C. Never touch uninsulated telephone wires or terminals
unless the telephone line has been disconnected at the
network interface.
D. Use caution when installing or modifying telephone lines.