DRUMFIT INDOOR 7000 MAGNO
DRUMFIT INDOOR 7000 MAGNO
41
40
ENGLISH
ENGLISH
Battery
If the data on the display can’t be seen clearly, replace the battery; this monitor uses two
"AAA" batteries. When replacing batteries, replace them all at the same time.
4. TECHNICAL SPECIFICATIONS
Product name: DrumFit Indoor 7000 Magno
Reference: 07086
Made in China | Designed in Spain
5. DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE), specifies that old household electrical appliances must
not be disposed of with the normal unsorted municipal waste. Old
appliances must be collected separately, in order to optimise the recovery
and recycling of the materials they contain and reduce the impact on
human health and the environment.
The crossed out “wheeled bin” symbol on the product reminds you of your obligation to
dispose of the appliance correctly.
Consumers must contact their local authorities or retailer for information concerning the
correct disposal of old appliances and/or their batteries.
6. TECHNICAL SUPPORT AND WARRANTY
This product is under warranty for 2 years from the date of purchase, as long as the proof
of purchase is submitted, the product is in perfect physical condition, and it has been given
proper use, as explained in this instruction manual.
-
The warranty will not cover the following situations:
-
The product has been used for purposes other than those intended for it, misused,
beaten, exposed to moisture, immersed in liquid or corrosive substances, as well as any
other fault attributable to the customer.
-
The product has been disassembled, modified, or repaired by persons, not authorised by
the official Technical Support Service of Cecotec.
-
Faults deriving from the normal wear and tear of its parts, due to use.
The warranty service covers every manufacturing defect of your appliance for 2 years, based on
current legislation, except consumable parts. In the event of misuse, the warranty will not apply.
If at any moment you detect any problem with your product or have any doubt, do not
hesitate to contact Cecotec Technical Support Service at +34 963 210 728.
fitter, you might need to train longer and harder. It is advisable to train at least three times a
week, and, if possible, space your workouts evenly throughout the week.
Approximately 7 hours of use per week is recommended.
Troubleshooting
If no number appears on the monitor, make sure all connections are correct.
If the problem persists, replace the batteries with new ones.
Recommendation
It is recommended to periodically lubricate the moving parts of the unit. To do so, apply
some silicone spray or gel to those parts, including pedals and flywheel. Then, run the device
normally for at least half a minute.
Control panel
Monitor operation
-
Time: 00:00-99:59 (minutes:seconds)
-
Speed: 00-99.9 km/h
-
Distance: 0.00-99.99 km
-
Calories: 0-999.9 kcal
Buttons
-
Mode button (8): press this button to select and view a certain function, press the mode
button for 3-4 seconds, the monitor is reset to zero (total distance cannot be cleared).
-
Set button (9): press this button to set the count value of a currently displayed function
(valid when Scan is not activated, not valid for total distance).
-
Reset/clear button (7): press this button to reset or clear the current data (valid when
Scan is not activated, invalid for full distance).
Operation
Automatic switch (Monitor): When there are buttons and sensor signal input, it will turn on
automatically.
When there is no signal input (key and sensor signal), it will automatically switch off after
four minutes.
Methods and steps of operation and adjustment
-
SCAN: displays all the measured values consecutively, one after the other.(1)
-
TIME: measures the time elapsed from the start of the exercise until the exercise stops.(2)
SPEED: measures instantaneous speed, reflecting the speed of the movement. (3)
-
DIST: measures the distance travelled from the start to the end of the movement. (4)
-
CAL: measures the calories burned from the start of exercise to the end of exercise. (5)
-
ODO: displays total accumulated distance. (6)
