TOTALPURE 2000 OZONE
26
ENGLISH
The cycles will run at the selected speed setting.
The operating cycle can be deactivated manually at any moment.
Set the speed so the device starts operating. By default, it will operate for one hour unless the user
changes it. The display will show "Hd".
If you lower the speed, the display will show "Ld", with a default operation time of one hour.
Press the button for approximately 3 seconds to turn the unit off.
Note: When turned on, the device will start working according to the previous settings.
Timer
Press the timer button to program the ozone generator. It will display 1 h by default. Press the button
repeatedly to program it from 1 to 9 hours. It can also be programmed to start operating in standby
mode.
The display will show "Hd" or "Ld" unless the user changes the settings.
After setting 3 seconds, the speed will be displayed again.
After pressing the "cycle" button, the display will show "1", "2" or "3" briefly and display the speed
again.
After pressing "Timing", the screen will display for 3 seconds "1 H", "2H"... "9 H". Then, it will display
the speed again.
The display will always be on while the unit is operating and it will flash in standby mode, showing
"--".
Summary of Contents for 05617
Page 60: ...TOTALPURE 2000 OZONE 60 1 2 3 4 5 6 7 Fig Img Abb 1 ...
Page 61: ...TOTALPURE 2000 OZONE 61 Fig Img Abb 2 Fig Img Abb 3 Fig Img Abb 4 ...
Page 62: ......
Page 63: ......
