CE+T Power BRAVO ST-120 VAC-UL, User Manual

Page: 26 / 38

9. Human-Machine Interface
9.1 Inverter module (Requires firmware V208.4 or higher)
=
~
=
=
=
~
AC OUT
DC IN
AC IN
Inverter Status Output Power Status
Inverter Status LED Description Remedial action
OFF No input power or forced stop Check environment
Permanent green Normal operation
Blinking green
Converter OK but working conditions
are not fulfilled to operate properly
Blinking green/orange
alternatively Recovery mode after boost
(10 In short circuit condition)
Permanent orange Starting mode
Blinking orange Modules cannot start
Check T2S configuration or Module with wrong
firmware. Need firmware V208.4 or higher.
Blinking red Recoverable fault
Permanent red Non recoverable fault Send module back for repair
Output Power (redundancy not counted)
<5%
5% to
40%
40 to
70%
80 to
95%
100%
100% =
overload
Output Power (redundancy not counted)
× × ×
Status output power LED × ×
×
1B 1P 2P 2P 3P 3B Behaviour (B = Blinking and P = Permanent )
9.2 T2S ETH
•
Alarm indication on Catena (Urgent / Non Urgent / Configurable)
- Green:
No alarm
- Red: Alarm
- Flashing Exchanging information with inverters
(only Configurable alarm)
•
Outgoing alarm relay delay time
- Major and Minor
Adjustable from 2 to 60 seconds
•
Parameter setting via Laptop.
•
Factory default according to list of set values.
Major Alarm
Ethernet Port
System Status
Minor Alarm
Micro SD Card
Human-Machine Interface
26 - Bravo ST 120 Vac - 2+1 Redundancy - User Manual - v1.0