(x4)
(x2)
1
(x4)
(x2)
2
(x4)
(x2)
3
4
cdvigroup.com
Before commencing assembly, ensure you have the correct tools and accessories
depending on the installation.
Position the box-section backplate,
complete with pre-fitted electro-
magnetic locks, on to the door frame
(or fixed door leaf if installing onto
double doors) – ensure the positioning
will allow for the archi-tectural handle
to close securely over the section. Once
you are satisfied with the position,
mark the vertical and horizontal
holes, then drill as required. Take note
of the cable entry holes, and feed
the cables through. Fix the section into
place, then wire the electromagnetic
locks in accordance with the wiring
schematic in Section 5. Fit the box
section cover into place, fir the end
caps and secure with the M4 screws
provided.
With the door closed, position the
architectural handle onto the edge of
the opening leaf of the door, ensuring
the handle covers the box-section. Mark
the vertical and horizontal holes, drill
as required, then temporarily fix the
handle leaving a small gap around the
box section – check the alignment of
the magnets in the box section with the
magnets in the handle.
Adjust if necessary, then once satisfied,
secure the handle by completing
the fixings.
To finalise the assembly, tighten all
fixings, and protect the handle fixing
section by fitting the cover and end caps.
EN
BO800RN
Retrofit housing and retrofit handles
iNstaLLatiON MaNUaL
3] MOUNtiNG Kit
4] assEMBLY
Profiled
handle with
end caps
Profiled
handle
fixings
cover
Box section
back-plate
Box section
cover
End caps
screws kit
Manual
BO800RN
1
1
1
1
2
1
1
PBO400RN40
1
1
1
1
2
1
1
PBO800RN60
1
1
1
1
2
1
1
