2
Specification
Weighing range (max) (d)
10000 g
Readability (d)
5 g
Linearity
15 g
Minimum unit weight for piece
counting
10 g
Reference quantities for piece
counting
5, 10, 20, 25, 50
Warm-up time
30 minutes
Recommended Calibration
weight (not included)
10000 g (F1)
Stabilization time (typical)
3 sec.
Operating temperature
+ 5
°
C .... + 35
°
C
Operating Humidity
max. 80 % (not condensing)
Intended use
The scale you have acquired serves to determine the weighing value of the material to be weighed. It is
intended to be used as a non-automatic scale, i.e. the material to be weighed is manually and carefully
placed in the center of the platform. The weighing value can be read off after a stable weighing value
has been obtained.
Inappropriate use
Do not use the scale for dynamic weighing. In the event that small quantities are removed or added to
the material to be weighed, incorrect weighing results can be displayed due to the stability
compensation in the scale. (Example: slowly draining fluids from a container on the scale.)
Do not leave a permanent load on the platform. This can damage the measuring equipment.
Be sure to avoid impact shock and overloading the scale in excess of the prescribed maximum load
rating (max.), minus any possible tare weight that is already present. This could cause damage to the
scale.
Never operate the scale in hazardous locations. The series design is not explosion-proof.
Structural alterations may not be made to the scale. This can lead to incorrect weighing results, faults
concerning safety regulations as well as to destruction of the scale.
The scale may only be used in compliance with the described guidelines. Varying areas of
application/planned use must be approved by CDN in writing.