37
Installation
Transit bolts and plastic spacers,
located at the rear of the appliance,
must be removed prior to using the
appliance to prevent damage.
•
Loosen the transit bolts using a
10mm spanner by turning them
anticlockwise and then remove
them.
•
Remove the plastic spacer
secured by each transit bolt.
•
Fit the plastic blanking plugs (supplied) to seal the bolt
holes against water ingress.
Warning: Do not turn the machine upside down or lie it on its
side.
Do not throw the transit bolts or plastic spacers away.
If you need to move the washer dryer after installation you
should first replace the transit bolts.
Do not install your machine on rugs or similar surfaces.
For your machine to work silently and without any vibration, it
should be installed on a flat, non-slippery and solid surface.
Never put cartons, wooden blocks or similar materials under the
machine to level the surface under the appliance
