6
(D1=D2). (Refer to the figure below.) Observe if there is any collision or friction between
the camera and the vitreous cover. If there is any, adjust the camera.
2. Connect Lens Controlling Cable
Camera Lens Controlling Cable should be provided by the camera supporter.
Connect the camera controlling cable well according to the corresponding relationship
between the camera and the outlet of PCB panel shown in the following table.
Controlling signal of the camera lens
Corresponding outlet on PCB panel
Camera power supply
+12VDC, GND
Lens Zoom
ZOOM
Lens Focus
FOCUS
Lens Iris
IRIS
Lens Controlling public ground
COM
3. Connect Video Cable
Connect BNC video outlet with the video output outlet of the camera, then use the
binding wire to tie the video cable inside the camera and the lens cable into the hole
beside the lens connecting outlet on the PCB panel. After installing the camera, please
set up communication protocol, Baud rate, address, etc.
2-3 Connection of the Camera and the Housing
Install the well-setup module equipped with camera into the housing. Procedures
shown below:
Summary of Contents for JE900BN
Page 24: ...23...
