CCTV JE900BN, User Manual

Page: 18 / 24

17
As per the method introduced above, adjust the unit well.
3-3 The particular command and its Definition
The below table is the particular short command for operate the PTZ camera with
protocol “Pelco-D” and “Pelco-P”
These short commands are important for operation the PTZ function. Please remember
Code No. Definition Code No. Definition
160
begin with left/right limiting position
setup
140 Begin with the tour group setup
161 Finish left/right limiting position setup 141 Finish the tour group setup
130 Set up left limiting position 142 Start Tour Group
131 Set up right limiting position 162 Activate Home Position function
132 Start left/right scanning 163 Disable Home Position function
135 Start 360°scanning of the pan/tilt 164 Set up Home Position
138 Stop auto scanning of the pan/tilt
Table 7: short command for operate the dome camera
The below table is the particular short command for operate the PTZ camera with
protocol “Pelco-D1”
Code No Definition Code No Definition
120
begin with left/right limiting position
setup
110 Begin with the tour setup
121 Finish left/right limiting position setup 111 Finish the tour setup
100 Set up left limiting position 112 Start Tour
101 Set up right limiting position 122 Activate Home Position function
102 Start left/right scanning 123 Disable Home Position function
105 Start 360°scanning of the pan/tilt 124 Set up Home Position
108 Stop auto scanning of the pan/tilt
Table 8: functions with preset position number smaller than 128
For all kinds of operations introduced in the following paragraphs, if PELCO-D1 protocol
is chosen for the control, please choose the Function Codes inside the bracket to
operate.
3-4 Set up and Preview Preset Positions
The function of preset positions works in this way: the dome camera saves the
current pan/tilt parameters in number order (1-16), quickly previews those parameters
when needed, and adjust the dome to the corresponding positions. Users can use