CCTV JE900BN, User Manual

Page: 12 / 24

11
1. The diameter of the flange on the outdoor vertical pole should be at least 20cm
more than that of the installing flange of the Pole bracket.
2. The cable should not go through the cable-slot on the flange edge of the Pole
bracket, it should go through the central hole of the bracket.
3. The 3 bolts fixing position should be sealed with sealant to prevent the rain water
from seeping in.
2-7 Power supply adapter installation
To make sure the power source is at DC15V 2A for the PTZ camera, you’d better to
install the AC/DC power adapter inside the arm bracket or next to the PTZ camera
to avoid the drop of voltage, due to there is a big internal resistor in the DC circuit.

Step 1
Put the power adaptor into the well connected wall bracket and pin the power
adaptor with the power pinning board lest the power adaptor slides out. (See the above
figure)

Step 2
Pull the power, video and controlling integrated cable out of the bracket tube via the
cable out-going slot, then fit the dotted-line part of the bracket shown in the figure to the
two corresponding pegs on the installed peg-board, then push the bracket downward
until it locks in place. Make sure the bracket fits well with the bracket installing bottom
board, then tighten the Tightening Screw on the bracket. (See the above figure)