8/7/2018
Rev. 1.0
22
Tower Series PIM Analyzer Remote
Operation User Guide
3.1.9.1.8 Turn-On and Turn-Off of Transmitter (TX)
Please note that there is an icon to the “right” of the PIM and Return Loss readings which
appears as if it is a slider. Clicking the “TX icon” (which changes the icon by showing the bar next
to the letters TX as having shifte
d to the “right” and turning “red”) as shown in
figure 23
, tells the
Tower Series PiMPro to “Turn ON” the RF Power for PIM and Return Loss testing. If you are
close to the PiMPro unit, you should see the “RF ON” RED LED turn on when you activate the
“TX ON” on the Remote tablet.
Note: Prior to
“Turning ON” the Tower Series PiMPro, make
sure that it is terminated with the Low PIM Load, and not operating into an open.
Clicking the “TX icon” again changes the position of the bar as having shifted to the left and
turning gray. This “Turns RF Power OFF” on the Tower Series PiMPro.
Figure 23
– Icon to Turn TX (RF) ON
3.1.9.1.9 Record Reading
Record Reading can also be set-up as on the Tower Series PiMPro. Pressing the Record
Reading icon on the Screen will open up the pop-up window to enter the Site Info. Once the
Company, Site and Technician information is entered, the user must press the “check mark”
(accept input information) on the tablet in order to get to the next screen. See
figure 24
below for
an example.
Figure 24
– Site Info Pop-up Window after Depressing Record Reading
This now opens the “”Sector Info” pop-up window. The user must enter the “Sector” and “Feeder”
information.
To accept the information entered in the “Sector Info” screen, press the “OK” button
on the screen. See
figure 25
for an example.
