RRS-2 Technical Manual 39
© 2009 CBS ArcSafe
®
2012-04-18
4.0 Radio Remote Troubleshooting Guide
Symptom
Problem
Solution
The system power will not
energize when using the remote,
but the system power energizes
and runs with the normal
pendant station.
The emergency-stop push-
button is latched.
The radio remote is not
communicating with the
receiver.
The radio remote is designed
for another unit.
(PS-R4,PS-R6)
The radio remote’s batteries
are dead and therefore cannot
connect .
Rotate the emergency stop
pushbutton clockwise to reset.
Ensure that the remote has been
properly connected wirelessly to
the receiver. This can be done by
either inserting the green key (PS-
R3), rotating the operating switch
to the start position (PS-R4), or
pressing the start button (PS-R6).
Ensure that the radio remote being
used is the radio remote provided
for that particular unit, the radio
remotes are NOT interchangeable
between systems and are unique
for every system.
Replace the 2 AA batteries inside
of the remote. This may require
you removing the remote from its
protective plastic cover and
carefully unscrewing the back
cover on the remote.
The remote pendant station is
“dead,” but the system power is
on.
The radio remote is not
communicating with the
receiver.
(PS-R3)
The radio remote is designed
for another unit.
The radio remote’s batteries
are dead.
Ensure that the remote has been
properly connected wirelessly to
the receiver. This can be done by
inserting the green key (PS-R3),
rotating the power switch to the
start position (PS-R4), or pressing
the start button (PS-R6).
Ensure that the radio remote being
used is the radio remote provided
for that particular unit, the radio
remotes are NOT interchangeable
between systems and are unique
for every system.
Replace the batteries inside of the
remote. This may require you
carefully removing the remote
from its protective plastic cover
and carefully unscrewing the back
cover on the remote.
