RRS-2 Technical Manual 32
© 2009 CBS ArcSafe
®
2012-04-18
2.0 Camera System Set-up
The wireless camera is either hard mounted to the remote racking system or magnetically mounted to the
switchgear being racked; turning the ‘CAMERA’ switch, located on the Current Control Module on the RRS,
clockwise to the ON position supplies power to the camera. When power is supplied to the camera, the camera
then transmits the video signal wirelessly to the receiver. When the receiver is supplied power via the battery
or the AC power cable provided, it outputs the signal to the LCD display.
ATTENTION
The maximum reception distance for the wireless camera system is 300 ft, however if
there are any obstructions between the camera and the receiver some interference may
build up and distort the wireless signal.
3.0 Camera System Operation
The system is operated in the following manner:
(1)
Charge the LCD display.
a.
The initial charge was performed by CBS ArcSafe® personnel, subsequent charges are
performed by plugging the LCD power cable into AC power.
(2)
Power on the camera.
a.
The camera is located on the CBS ArcSafe® Remote Racking System; the camera is powered
on by turning the ‘CAMERA’ switch located on the Remote Racking Unit Control Panel
clockwise to the ON position.
(3)
Power on the wireless camera kit.
a.
Ensure the Monitor Case is fully charged or is connected to AC power.
b.
Power on the monitor by turning the main power switch clockwise.
(4)
Changing Wireless Channels
a.
Sometimes there will be a need to change wireless channels if too much interference
affects your signal, if this is done please make sure to change wireless channels on
both the wireless camera and the wireless receiver to make sure they are both
sending/receiving to the same channel after being changed.
