RRS-2 Technical Manual 19
© 2010 CBS ArcSafe
®
2012-04-18
3.6.2 Automatic Current Control Time Stop Configuration
One of the key features of using the automatic current control module configuration is being able to
change the time stop parameters. This allows for the user to set how long the current can be over the set
amount before turning off, anywhere from 0 seconds to .9 seconds in increments of .1 seconds (for
versions 2.4 or newer). To set the Time Stop follow the following instructions.
1.
Press both the Install and Remove buttons at the same time.
2.
Press the Up or Down buttons to set the Time Stop length from 0 seconds - .9 seconds.
ATTENTION
The factory default and recommended setting for normal use is .1 seconds.
3.
Press either the Install or Remove buttons to exit the Time Stop editing feature, the Time
Stop will be automatically saved.
