3. Installation
② Connect IDE Cable to Hard Disk
• Insert HDD with Red Cable mark towards Power Cable Plug.
• Connect Power Cable Plug to HDD, with red wire to left.
※ If installing one HDD, connect with End Connector (Black)
If installing 2nd HDD, connect with Middle Connector (Gray)
One HDD Installation
Two HDD Installation
Bracket Installation
③ After Finishing Cable Connection, Attach Hard Disk with screws to the Drive Bracket
• The IDE interface can connect two HDDs to one
cable (port). For the purpose of preventing
confusion, the two HDDs can be setup as ‘Master’
and ‘Slave’. ’Master’ is used for a single or primary
HDD and ‘Slave’ is used for secondary HDD.
- Master or Slave?
Tip
IDE2
IDE1
- On the Main Board
• When Installing a Master HDD, you must connect
the IDE Cable to IDE1 Port on the main circuit board.
13