1222-E OPERATING INSTRUCTIONS
WARNING: To ensure operator safety and efficient operation of the
CaviBlaster
TM
, it is essential to follow these instructions.
Preparing the CaviBlaster
TM
system for operation:
1. Inspect the CaviBlaster
TM
power unit, hoses and Zero Thrust Gun for any signs of damage.
2. Inspect inlet strainer (Figure 1) to ensure that it is not clogged. Clean if necessary.
3. Check for proper oil level in pressure pump (Figure 2).
4. Fill lubricating oil to proper level in the pressure pump (yellow cap on pump) (Figure 3) per
manufacturer’s operating manual.
**SAE 30W Non-detergent oil**
Figure 1
Figure 2
Figure 3
5. To supply water to the CaviBlaster
TM
power unit, connect a 1″ (25 mm) diameter feed hose to
the cam-lock plug on the inline strainer inlet (Figure 4). Either fresh water or seawater can
be used with this system.
The water source must supply the CaviBlaster
TM
with water at a
volume of greater than 12 gallons (45 liters) per minute at a maximum pressure of 70-psi (5
bar)
.
Ensure that the feed hose is connected to the pressure pump and the water is on prior to
starting the pressure pump.
6. Connect the 1″ (25 mm) red rubber bypass hose to the cam-lock plug on the pressure-
regulating unloader (Figure 5). The bypass hose has a cam-lock socket on one end. Direct
the bypass hose away from the working area and secure the hose.
Page - 2
For more information please email [email protected] or call 1-(352)275-5319
