Summarizing the operating instructions:
1. Inspect the system for damage. Clean the inlet strainer. Check pressure pump
oil level.
2. Attach the feed and bypass hoses.
3. Start the water supply and ensure that the system is primed (water should be
coming out of the pressure hose quick-connect plug).
4. Attach the pressure hose and Zero Thrust Gun.
5. Connect the power cable to the power source.
6. Make sure that the diver is ready to work and that the Zero Thrust Gun is
submerged in the water. Apply hearing protection if the diver is not wearing a
helmet.
7. Start the motor.
8. Activate the cleaning cavitation stream by squeezing the Zero Thrust Gun
trigger to open or “ON.”
9. Proceed with cleaning.
10. Stop the motor.
11. Shut off the water supply to the pump.
12. Release pressure from the hose(s) by squeezing the Zero Thrust Gun trigger to
the open or “ON” position
while under water
.
13. Remove the Zero Thrust Gun from the water.
14. Disconnect the power cable from the power source.
15. Flush the system and rinse the outside of the power unit with fresh water.
Page - 7
For more information please email [email protected] or call 1-(352)275-5319
