Pg 12
Installation (Continued)
Install the baffle filters into the range hood.
Figure 8.
If your model size has baffle filter spacers:
they are easier to install before the baffle filters;
and are more easily installed at the sides of the range hood; use the same steps as instructed
in Step 7.
Double Check all power connections, ducting connections, fastened screws,
remove any
loose debris or tools, and then apply power from your main switch board. Test Ground Fault
Circuit Interrupter (G.F.C.I. or G.F.I.)
Test operations
(see Range Hood Operations Page 13). Leave this manual for the range
hood owner.
Figure 6
Figure 7
Figure 8
a)
Angle the baffle filter so that the rear edge of the baffle filter enters the range hood
cavity, and touches the back wall of the range hood.
b)
Then lift the front edge of the baffle filter so that it aligns with a groove in the lower
front panel of the range hood assembly.
c)
Then slide the baffle filter towards the front of the range hood body, into the groove of
the lower front panel of the range hood assembly.
d)
Keeping pressure on the baffle filter to hold it towards the front of the range hood
body, while in the groove of the lower front panel of the range hood assembly, lower the
rear edge of the baffle filter onto the grease catch, previously installed in Step 6.
e)
Ensure the baffle filter partially rest inside the opening of the grease catch, against the
extended lip of the grease catch.
f)
Slide the baffle filter to one side and repeat for remaining baffle filter(s).
3.
3.
4.
5.
6.