CT24 MCU
User Manual
9
9M02-7608-A001-EN
Version 2.0
WARNING
THE REMOTE CONTROL SYSTEM YOU HAVE PURCHASED IS DESIGNED TO STOP IN A
SAFE MODE UNDER A VARIETY OF CONDITIONS. SOME EXAMPLES OF THESE
CONDITIONS ARE EXCESSIVE RADIO SIGNAL INTERFERENCE, LOSS OF BATTERY
AND/OR ELECTRICAL POWER, FAILURE OF CERTAIN COMPONENTS, OPERATION
BEYOND SIGNAL RANGE AND OTHERS. ALTHOUGH CATTRON AND ITS SUBSIDIARIES DO
NOT SPECIFY THE POSITION OF THE OPERATOR WHEN CONTROLLING THE EQUIPMENT,
WE ARE AWARE THAT SOME USERS ARE INSTRUCTED AND TRAINED BY THEIR
EMPLOYER TO RIDE THE EQUIPMENT IN A SAFE MANNER. IT IS IMPERATIVE THAT YOU
ARE PREPARED FOR AN UNPLANNED STOP OF THE EQUIPMENT AT ANY TIME AND DO
NOT PLACE YOURSELF OR OTHERS IN A POSITION WHERE THIS SITUATION MAY CAUSE
YOU TO FALL FROM THE EQUIPMENT. FAILURE TO USE CAUTION MAY LEAD TO INJURY
OR DEATH.
2.1
General Safety Information
•
Persons under the influence of drugs, alcohol and/or other medicine that impairs reaction may not
assemble, disassemble, install, put into operation, repair or operate the product.
•
All conversions and modifications of an installation or system must conform to the relevant safety
requirements. Only qualified, trained, authorized personnel may perform work on the equipment, in
accordance with the relevant safety requirements.
•
In the event of malfunction and/or visible defects or irregularities, the product must be stopped, switched
off, and the relevant master switches also switched off.
WARNING
Observe the statutory regulations and directives applicable for the intended purpose, e.g.:
•
Accident prevention regulations
•
Safety rules and directives
•
Standards
•
Generally applicable statutory and other binding regulations for accident prevention and
environmental protection, and general safety and health requirements.
•
Keep the operating manual permanently accessible at the place of product use.
•
The personnel assigned to work on/with the product must have read and understood this operating
manual and the safety instructions.
•
The safety instructions must, if necessary, be supplemented by the user with instructions concerning the
work organization, work sequences, qualified personnel, etc.
•
All repairs made during the warranty period must be carried out by the manufacturer or appointed
authorized service center; failure to comply will invalidate the warranty.
•
Only trained personnel may perform maintenance and repair on the product.
•
All repairs made should be carried out in a suitably clean static-safe environment, free from contaminants
such as metal filings, water, oil, etc.
•
It is the user’s responsibility to ensure that the product always operates in good condition and that all
applicable safety requirements and regulations are observed.
•
Product modifications may not be carried out without the consent of the manufacturer.
•
Original spare parts from the manufacturer must be used.
•
Carry out periodic inspections and/or maintenance either required by law or prescribed in the user manual
within the required intervals.
!
!
